Air Monitoring Technician Practice Exam

These questions are part of the practice quiz. Start practicing

• Which monitoring type is primarily used to enforce emission standards at a source such as a smokestack?
• NESHAP is an EPA regulation.
• The statement 'The magnification of the PCM eyepiece is 20x' is true.
• Breakthrough in VOC sampling is often observed when sorbent capacity is exceeded. Which statement best describes its effect?
• Besides PM2.5 and O3, which pollutants are sometimes monitored to meet NAAQS according to the material?
• Define data completeness and data QA qualifiers for ambient monitoring data.
• Which statement best describes the purpose of chain-of-custody in ambient sampling?
• Which PM monitoring method uses beta attenuation to estimate mass and is less affected by sample heating?
• What is the difference between NO2 and NO measurement in air monitoring?
• Name two federal regulations that govern ambient air monitoring and reporting in the United States.
• OSHA stands for which agency?
• What is the purpose of field blanks versus trip blanks in sample handling?
• Why is sample storage temperature important for certain air samples?
• What counting criterion is described for the Walton-Beckett Graticule?
• In bulk analysis, PLM stands for which microscopy technique?
• What is the purpose of the EPA Air Quality System (AQS)?
• PPE stands for which of the following?
• What is the difference between the detection limit and the quantitation limit?
• Which is a typical QA/QC plan element for an ambient monitoring program?
• Which expression defines sample count in this context?
• How should data quality issues due to instrument downtime be addressed in reporting?
• Mixing height, when available, influences ambient PM measurements because it affects which of the following?
• What is data completeness in a monitoring network?
• PEL values for asbestos are expressed in fibers per cubic centimeter.
• Explain QA/QC concept of field blanks in filter-based sampling.
• Which is the concentration unit used in this method?
• Which two pollutants are commonly monitored to meet NAAQS requirements?
• What are the requirements for clearance air monitoring required under AHERA?
• Under NESHAP regulations, what is the primary focus of monitoring?
• Which act is commonly associated with asbestos hazard management in schools?
• What is hold time in sample handling?
• What is the flow rate range for sampling on 0.8 micron MCE filters?
• What is the filter area for a 25 mm cassette?
• Why are collocated and duplicate samples used in QA/QC?
• Which statement best describes the difference between PM2.5 and PM10?
• Which safety measures should be taken when performing field sampling in confined spaces?
• What distinguishes primary data from backup data in QA/QC documentation?
• AIHA stands for which organization?
• OSHA is the federal agency responsible for what?
• Six silicate minerals are identified by govt. regulations as asbestos.
• How many box fans are required under AHERA to conduct clearance?
• What is the purpose of field blanks in QA/QC?
• Which microscopy technique is used to count asbestos fibers in air samples?
• Five of the asbestos minerals belong to the serpentine subgroup.
• What is the minimum sample volume required for this sampling method?
• Why is it important to calibrate gas concentrations to the expected ambient range?
• Which of the following is not commonly classified as an asbestos-related disease?
• What type of air monitoring is commonly associated with OSHA regulatory requirements?
• If a filter gained 6 µg and the sampled volume was 3 m³, what is PM concentration?
• What action is typically taken when a drift is detected during instrument performance verification?
• What does F/cc stand for in the context of asbestos fiber concentration measurements?
• In QA/QC, what is the purpose of collocated sampling?
• What is zero drift and how is it mitigated?
• NESHAP stands for National Emission Standards for Hazardous Air Pollutants.
• What does the abbreviation CV stand for in statistics?
• Which statement best describes why ambient monitoring networks are designed?
• AHERA regulations are specifically designed for which setting?
• F/cc is the unit used to express what in asbestos fiber measurements?
• Asbestos-containing packings, gaskets, resilient floor covering, and asphalt roofing products containing more than 1.0% asbestos as determined by polarized light microscopy are categorized as which?
• What is the purpose of EPA Method 5 in PM stack sampling?
• Which statement best describes the Walton-Beckett Graticule criterion?
• For OSHA personal samples, identify the method described as appropriate.
• Which method is appropriate for OSHA personal samples according to the source material?
• Under NIOSH-7400, what is the PCM flow rate range?
• In AHERA clearance monitoring, the specified number of samples is?
• Which asbestos type is the most common in the United States and is commonly referred to as blue asbestos?
• What is the purpose of zero and span checks on gas analyzers?
• What is the filter area for a 37 mm cassette?
• EPA Method 29 is used for what purpose?
• What is the primary purpose of a calibration gas in instrument calibration?
• What is the stated limit of quantification?
• Which cassette has the larger filter area according to the data?
• NIOSH stands for which organization?
• Which option best aligns with the recommended approach for OSHA personal samples as described?
• The statement 'The eyepiece of the phase contrast microscope is called the objective' is true.
• What does the acronym DOAS stand for in ozone measurement?
• TSI is an acronym for which term?
• Which diseases are commonly recognized as major asbestos-related diseases?
• In data reporting, what is the purpose of data qualifiers?
• Which designation is achieved if no sample is reported greater than 0.01 F/cc?
• PAT round is associated with which program?
• What does f/cc stand for in air monitoring?
• Which statement best describes the regulatory purpose difference between ambient monitoring and stack testing?
• Which class of compounds is particularly prone to degradation or adsorption if not cooled during storage?
• The asbestiform varieties of chrysotile, amosite, crocidolite, tremolite, anthophyllite, and actinolite are examples of which of the following?
• Which filter material is specified for sampling at 0.8 micron?
• NVLAP is administered by which organization?
• In air sample analysis, Phase Contrast Microscopy is abbreviated as which option?
• What is the definition of the quantitation limit?
• Which of the following is true about the PCM eyepiece magnification?
• TAHPR requires at least how many liters of air collected for baseline and clearance samples?
• Regulated minerals known as asbestos are chrysotile, amosite, crocidolite, tremolite, actinolite & anthophyllite.
• NVLAP is an accreditation program administered by which entity?
• What is the magnification of the eyepiece of the PCM scope?
• What does PEL stand for?
• Which EPA method is used for the determination of asbestos in bulk building materials?
• In air sampling, filters are loaded in what type of cassettes?
• Field area of the graticule is determined by multiplying which two quantities?
• Which statement about NAAQS is true?
• In TEOM measurements, which statement about humidity and temperature is correct?
• When smoking is added to asbestos exposure, what is the observed effect on mortality risk?
• How should you verify that a sampling pump flow rate is within specification?
• Which of the following methods is identified as the OSHA reference method for personal samples?
• The removal, encapsulation or enclosure of asbestos to reduce airborne concentrations is called which of the following?
• AHERA calibration uses which microscopy method?
• Which term describes insulation that can be easily crumbled by hand?
• 40 CFR Part 53 is primarily concerned with Ambient Air Monitoring.
• Which technique is commonly used to determine asbestos content in bulk building materials?
• Which mineral category does chrysotile belong to?
• Which of the following best describes the purpose of AP-42?
• What type of air monitoring is typically associated with AHERA compliance activities?
• In this protocol, Volume is defined as which of the following?
• Which of the following is an example of Category I nonfriable ACM?
• Name two common methods for measuring ozone in ambient air.
• In QA/QC data validation, which scenario would be flagged as an anomaly?
• AHERA stands for which act?
• What key meteorological parameters should be recorded with ambient air monitors?
• The 30-minute Excursion Limit set by OSHA is 1.0 f/cc.
• What are common pump problems that can affect ambient air sampling flow rate, and how are they mitigated?
• What does TWA stand for in occupational exposure contexts?
• What is the primary purpose of a collocated sampler in ambient particulate matter monitoring?
• On-site preparations or cleanup related to abatement are referred to as which of the following?
• What does NVLAP stand for?
• Which statement correctly defines IDL and MDL?
• Who must be sampled by your employer for asbestos exposure?
• A material that, when dry, cannot be crumbled by hand pressure and contains more than 1.0% asbestos as determined by polarization microscopy is classified as which category?
• In gravimetric PM measurement, the PM mass is determined by which of the following?
• In sorbent tube sampling, which statement correctly defines a blank?
• Who shall conduct the final visual clearance inspection?
• What is data validation in ambient monitoring?
• Which minerals are included in the asbestiform varieties?
• Which factor drives photochemical processes that can influence ambient PM measurements?
• Which of the following minerals is not a regulated asbestos mineral?
• Which OSHA standard code covers respirators?
• Crocidolite is an amphibole and is known as the blue asbestos.
• The OSHA reference method is an analytical technique used for OSHA personal samples.
• Chrysotile is a serpentine mineral.
• Which monitoring methods are used for clearance air monitoring?
• Asbestos minerals are silicate minerals.
• ACM stands for in asbestos terminology?
• What does the EPA Air Quality System (AQS) provide access to?
• Which organization specifies a PCM flow rate range of 0.5 to 2.5 LPM?
• Which of the following is an example of the minimum sample volume required?
• All asbestos minerals are serpentine.
• Which ozone measurement method relies on ultraviolet light absorption?
• Which of the following statements about the PCM apparatus is accurate according to the material?
• What is the purpose of collocated sampling in ambient air QA/QC?
• Which condition is primarily a fibrotic scarring of the lungs caused by asbestos exposure?
• Asbestos minerals include amphiboles.
• Define AQI and how it relates to pollutant concentrations.
• The statement 'The eyepiece of the phase contrast microscope is called the objective' is true or false?
• Which expression represents fiber density in this method?
• What do data validation and reporting protocols typically include?
• Which analytical technique is the appropriate method for OSHA personal samples?
• Which expression defines the ratio used to adjust fiber counts by background subtraction?
• How do you calculate PM concentration from a filter weight difference and known sample volume?
• How many silicate minerals are identified by government regulations as asbestos?
• What is the minimum number of samples collected on 0.8 micron mixed cellulose ester (MCE) filters loaded in conducting cassettes with extension cowls?
• Materials or products that contain more than 1.0% asbestos, as determined by EPA methods, are classified as what?
• What is the difference between NAAQS primary and secondary standards?
• In sorbent tube sampling, what does a blank indicate?
• TEM stands for which instrument in air/bulk analysis?
• Which two federal agencies regulate asbestos and what are their major regulatory frameworks?
• Which physical property of asbestos is commonly cited as contributing to its hazard in construction materials?
• Which of the following statements describes typical physical characteristics of asbestos?
• What is the concentration unit used in this protocol?
• What is the relationship between ambient monitoring and PSD as described?
• What is the OSHA permissible exposure limit (PEL) for asbestos as an 8-hour time-weighted average (TWA)?
• What is AP-42?
• The limit of detection is given as a range in fibers per square millimeter. Which option expresses this range?
• Chrysotile is known as the brown asbestos.
• How is a calibrated instrument defined?
• Which of the following statements correctly describes the magnification of the PCM eyepiece?
• Which quantity explicitly uses sample time in its calculation?
• What does zero adjustment accomplish in calibration gas use?
• How do ambient air monitoring and emission monitoring differ?
• Which term describes the observer's lens you look through in a microscope?
• Chrysotile is white asbestos.
• Ambient monitoring's role in PSD increments is primarily for which regulatory action?
• The 8-hour Time Weighted Average (TWA) PEL set by OSHA is 0.001 f/cc.
• Which document is NOT required to be on-site for an AMT/Project Manager?
• Ambient area samples should be collected at locations representative of what?
• How does a chemiluminescence NOx analyzer work?
• In the context of microscopy, what term correctly refers to the lens you look through?
• Which asbestos fiber type is brown asbestos?
• What health effects are associated with asbestos exposure?
• What is a drift/check procedure for instruments?
• Distinguish between a gravimetric PM sample and a real-time PM monitor.
• Amosite asbestos is found in 95% of the products which contain asbestos.
• In VOC sampling with sorbent tubes, which statement best defines breakthrough?
• What factors determine whether a monitoring site provides representative data for a community?
• The collection of airborne samples for analysis of fibers is called what?
• What is a TEOM and how does it differ from a BAM for PM monitoring?